Lychee Support Hub

Get the original bracing presets back if you edited or deleted them

If you changed or deleted one of the default bracing presets in Lychee Slicer, you can bring it back in two ways.

Option 1: Re-enter the default values (keeps all your other settings)

Open the bracing settings and either edit the existing preset or add a new one. Enter the values below, then click Save or Save and Apply. Every Gap value is 0 mm and every Non-Grid Step is 5 mm.

Default Bracing

• Global: Pattern type Mix, Bottom Start 1 mm, Diameter 0.9 mm, First Reinforcement 30 mm, Second Reinforcement 60 mm, Diagonal: No diagonal
• Top: Double diagonal, Repetition 1, Diagonal: No diagonal
• Middle: Simple diagonal, Diagonal: No diagonal
• Bottom: Simple diagonal, Repetition 1, Diagonal: No diagonal

Small Object Bracing

• Global: Pattern type Double diagonal, Bottom Start 1 mm, Diameter 0.8 mm, First Reinforcement 10 mm, Second Reinforcement 30 mm, Diagonal: No diagonal

Tall Object Bracing

• Global: Pattern type Mix, Bottom Start 1 mm, Diameter 2.0 mm, First Reinforcement 20 mm, Second Reinforcement 50 mm, Diagonal: Simple
• Top: Double diagonal, Repetition 2, Diagonal: Simple
• Middle: Simple diagonal, Diagonal: Simple
• Bottom: Double diagonal, Repetition 1, Diagonal: Simple

Strong Bracing

• Global: Pattern type Double diagonal, Bottom Start 0 mm, Diameter 1.0 mm, First Reinforcement 30 mm, Second Reinforcement 50 mm, Diagonal: Double

Option 2: Reset all your data

Resetting your cloud data restores every default setting at once, but it also removes your custom printers, resins and presets. Only use this if you want a completely fresh start. See Resetting the cloud data.